product name: Fall Film Evaporator
about price: $25,000 ~ $300,000USD
Minimum order quantity: 1set
delivery time: 1.5~3month
Terms of the transaction: FOB, CIF
payment method: T/T, L/C at sight
product description:
Multi-effect Fall-film Evaporator adopts falling film evaporating principal to heat the dilute solution up to boiling, making some part of water vaporize to attain the purpose of concentrating solution. This set of device is a new production through our operational development with each technical index up to international advanced standards.
Product Features:
1.Burst heat transmission and energy-saving. As a high efficient energy-saving concentration equipment, the evaporator can be assembled into two-effect, three effect, four-effect and five-effect evaporation system, fully utilizing the heat energy with low steam consumption. Just only one kilogram steam can evaporate four kilogram water. One effect evaporator shell works under vacuum state by conversion from pressure energy transfer to kinetic energy as a result of passing by jet heat pump. The tail steam of one-effect enters into pre-heater with some secondary steam of the preheated liquid pumped into one-effect again by jet heat pump, making maximum use of heat.
2.High Concentration Ratio(1/51/10), wide viscosity area(<400cp)Due to the falling film evaporation, the liquid film flows from top to bottom along the pipe wall. What's more, owing to the gravity, the solution with high viscosity flows and evaporates easily without coking.
3.The equipment can adopt downstream continuous feeding, as well as upstream or mixed-flow feeding. When adopting down-stream feeding, the flow direction of solution is the same to the heating steam, and the material enters into the one-effect. However, when adopting up-stream feeding, inlet the material from the last effect while outlet from the first effect.
4.The equipment can be control led manually, as well as semi-automatically or automatically. When control led automatically, the technological parameters such as steam pressure, the temperature of each control point, liquid level, vacuum degree and feed liquid gravity etc, feedback their value to computer control system through the sensor, so the operator can control these parameter by computer in the control room.
5.The equipment can be made of different kinds of material according to different materials and technological demands, such as TA2 Titanium, lCrl8Ni9Ti stainless steel, ordinary carbon steel(surface contacting with material i s bedaubed with special antiseptic and anti-rust paint). Under the condition of waste water treatment, bedaub the surface of ordinary carbon steel with special antiseptic and anti-rust paint can save a large sum of device investment, which have been tested by our factory repeatedly. So the equipment is really a preferred product for the waste water treatment station, meet(GMP)standards.
technical parameter:
MODEL |
DJM-500 |
SJM-1000 |
SJM-3000 |
SJM-6000 |
SJM-10T |
EVAPORATION CAPACITY (KG/H) |
500 |
1000 |
3000 |
6000 |
10000 |
STEAM PRESSURE (MPa) |
~0.3 |
||||
VACUUM DEGREE (MPa) |
-0.09 ~ -0.07 |
||||
OUTER SIZE(m) |
3.2x2.2x7.2 |
4.5x2.5x7.5 |
5.5x6x11 |
9.5x3.5x12 |
12x4x13.5 |
Application range:
It is widely applied to in such fields as food processing, juice concentrate, drinking production, dairy production, chemical industry, pharmaceutical industry, waste water treatment and environmental project etc , having advantages of low cost, easy operation and stable performance over traditional evaporator.