Home » Product » Utility System Equipment » Valve, Pipeline, Pump » TMF FLUOROPLASTIC MAGNETIC PUMP
TMF FLUOROPLASTIC MAGNETIC PUMP
Magnetic pump in normal operating conditions, there is no phenomenon of aging demagnetization with the passage of time , But when the pump is overloaded , blocked , slid or operated. When the working temperature is higher than the allowable temperature of magnetic steel , demagnetization will occur. Therefore, the magnetic pump must operate under normal operating conditions.
Strengthening sleeve :
Use high resistivity, high rigidity of non-metallic materials to make strengthening sleeve, effectively avoid magnetic eddy current. The pressure limit of the reinforced sleeve is 2.4 MPA.
Impeller and mouth ring :
The impeller is molded with fluorine plastic, and the steel insert is wrapped in fluorine plastic to ensure the strength of impeller. The oral ring is generally made of filled polytetrafIuoroethylene or silicon carbide material, super wear resistant and corrosion resistant.
Pump shell:
Made with HT200 lining F46, it can withstand part of the pipe gravity.
Base :
Adopt HT200 integral casting molding, the upper and lower all adopt the gantry milling machine to flatten, maximize to achieve the level and stability of the pump.
Sliding bearing :
Tetrafluorine filled SIN, SICZ SSIC and other materials, wear-resistantf corrosion resistance.
Special performance selection:
Optional name |
Description |
Electrostatic conduction device |
Prevention of fire caused by static electricity |
Dry grinding resistance device |
When there is no liquid, make sure it doesn't burn out |
Insulation sleeve |
Internal heat preservation of pump to prevent damage to magnetic pump |
High temperature resistance |
Suitable for use at 100 °C -170 °C |
Motor protection |
Can cut off the power instantly |
Special motor |
For special cases |
Special flange |
Can make any standard flange |
Easily damaged parts Description |
|
Impeller mouth ring |
24 hours operating conditions, it is recommended to check every 1500 hours. Regular switching machine operating conditions, it is recommended to check once a month. After the long-term shutdown of the operating conditions, it is recommended to check before the boot. |
Rotor |
|
Bearing |
|
Isolation sleeve |
|
Static ring |
|
Pump cover |